link do strony z Motion in Joy
Kod:
http://www.motioninjoy.com/download
+
cała instrukcja instalacji po eng
Initial One Time Setup for PS3 Controllers:
Setting the PS3 controller's master address to your phone's bluetooth mac address via Windows:

1. Download and install Motion in Joy.
2. Run DS3 Tool, installed in the previous step.
3. Click the "About" tab in DS3 Tool to see the version. If DS3 Tool is less than 0.5.0003 you will need to update.
4. Connect your PS3 Controller to your computer via the USB cable and wait while Windows recognizes the new device.
5. Click on the "BluetoothPair" tab.
6. In the DUALSHOCK 3 drop down list select your controller. If it says "Can't find connected(USB) Playstat":
* Click &quotriver Manager" directly above the drop down list
* Click "Load" and wait for it to finish
* Return to the "BluetoothPair" tab
7. Run CobaltController on your Windows Mobile device to get its BT address.
8. Enter that BT address into the text box directly above the DUALSHOCK 3 drop down list. Note that Motion in Joy uses a different MAC format (little endian vs big endian) so for example, a bluetooth address of "00:23:76:70:6B:4D" is entered it into Motion in Joy as "4d.6b.70.76.23.00"
9. Click the radio button next to this textbox to make sure that it uses the one you entered and not the one above it which is to connect your controller to your PC
10. Click "Pair Now"
11. If all went well your controller is now configured to talk to your Windows Mobile device. Go to the "Quick Start" tab and click &quotisconnect".
12. Unplug your PS3 Controller.
13. As long as you don't pair your controller with any other device (like your PS3) then you never have to do this again. If you do pair the controller with a another device and wish to re-pair it with your phone again, repeat the above steps.


Widcomm Stack Specifics:

* Turn on bluetooth and set it to discoverable. Thanks to ryotgz, skilty, and gorelshv for this information. I believe it is only required the first time you use CobaltController. Once you have successfully connected, BT does not have to be in discoverable mode any longer so you can change it back to invisible to save battery life.
* Make sure that the checkbox is not checked where it says "Allow only devices listed in 'My Devices' to connect".
* If you have never tried to connect the PS3 controller to your phone before (or at least not since the last hard reset or rom flash) it will fail to connect at first and you'll get a bunch of pop ups with PLAYSTATION(R)3 Controller shown in bold asking for the pin. Keep tapping cancel as it pops up and wait for everything to stop trying to connect. After all that, try again and it should connect just fine and should always connect right away in the future without the pin prompts. There is no pin (that I know of at least) I'm bypassing security on both the PS3 and Wii connections (even though we do know the pin for the Wiimote is the host's mac backwards.)